dragfan66's latest activity
-
Ddragfan66 reacted to North Idaho Wolfman's post in the thread Fixing hole in side of block with
Like.
Well that seals the fate of the poster and the thread... -
Ddragfan66 reacted to North Idaho Wolfman's post in the thread Fixing hole in side of block with Like.
I should clarify why welding the bolts was such a bad idea. When they break or loosen you'll play all heck to get them out. The lock...
-
DWe just made some comfort food last night. A macaroni / beef casserole with last years tomatoes. Good food for our nasty weather
-
Dhttps://youtube.com/shorts/f1slI4yTO_8?si=fY6WkGfa3nW82Lre
-
DLoaf of 8 grain bread fresh out of the Zojirushi. Cracked Emmer, Spelt, Rye, soft white, Groats, Barley, hard red, Einkorn, plus...
-
Ddragfan66 replied to the thread V3307 piston to bore clearance.OP and NIW both did a good job solving this problem before it became a costly mistake. (y) I wish Joe would read threads like this...
-
DSeriously Wolf you'll need a couple puffs off joe's pipe to grasp the whole picture the way joe does.
-
Ddragfan66 reacted to North Idaho Wolfman's post in the thread Fixing hole in side of block with Like.
You do NOT hammer the rod into place. You insert the hook into the hole in the gland then turn the gland cap to wind and set it all the...
-
DMost here may agree that that assessment applies to this entire thread!
-
Dfix it
-
Ddragfan66 replied to the thread Fixing hole in side of block.Nah, no welding required on that beast. Chainsaw is the way.