chim's latest activity
-
chim replied to the thread It looks like.While that should be true, the choices we have in an election are at best, the lesser of two entrenched evils. Money plays a much too... -
chim replied to the thread It looks like.At one time glaciers covered my zip code. Been warming ever since. People have become so accustomed to having their way they think the...
-
chim replied to the thread Daily Chuckle.Being totally honest there's not much need for a 4WD vehicle around here. Almost without exception roads are usually passable hours...
-
4-wheel drive doesn't get used much on ours. Mostly in the winter on the hills in NH. It does spend a lot of time going to the dealers...
-
chim replied to the thread 200 Hr maintenance.Although it looks like fun to try, I can't justify the cost of 5 blades:(
-
chim replied to the thread Diesel Prices.Harrisburg Costco was $3.19 for regular today.
-
chim replied to the thread RAM 2500 opinions.I'm not in the market for a truck but enjoy looking at them. That vertical piece of trim on the HD Ford's front fender is still...
-
chim replied to the thread 200 Hr maintenance.I've had a few Caroni decks and a couple LandPrides. I really like Caroni and would buy them again. The onlr Y blades are on flail mowers.
-
chim replied to the thread It looks like.A couple days next week are forecast to be over 100 degrees actual temps about 4 hours East of Skeets
-
chim replied to the thread L3600 (help please people!).I tried to search for parts on your side of the pond and didn't get very far. Some sites claim to have parts but show mostly fluids and...
-
chim replied to the thread Any one actually sat in the new L70 series tractor yet.After watching for about a year for a clean used factory-cabbed tractor I found this L4240HSTC with 977 hours. That was late 2018. It...
-
chim replied to the thread Finish mower options.I should have known that you had it under control. I reached as they would say at work an "optical confusion" :)
-
chim replied to the thread Finish mower options.Pardon my incorrect observation. In the pictures it looked to me as though the two joints were at different angles (rotation wise).
-
chim replied to the thread Finish mower options.Good morning Paul. The experience I have with drivelines is connecting and disconnecting implements, so I'm far from knowledgeable. If...
