bsamot69's latest activity

  • B
    bsamot69 replied to the thread L4400 fel not working.
    Explain about the bores. What should I be looking for as far as inspection?
  • B
    bsamot69 replied to the thread L4400 fel not working.
    The extended and compressed length should be on the sheets I sent you
  • B
    bsamot69 replied to the thread L4400 fel not working.
    Data sheets I have some pictures of the piston end/seals. I don't know what that chunky stuff is..it is hard as rock. The inside...
    • PXL_20251018_044030574.jpg
    • PXL_20251018_043958049.jpg
    • PXL_20251018_132126409.jpg
    • PXL_20251018_132806199.jpg
    • PXL_20251018_132213837.jpg
    • PXL_20251018_132202580.jpg
  • B
    bsamot69 replied to the thread L4400 fel not working.
    This loader/tractor we purchased for 1000.00. yes, a grand. The hour meter indicates 151 hours. The rest of tractor looks like it has...
  • B
    bsamot69 replied to the thread L4400 fel not working.
    The raise cylinder on left side retracted a little more than half and air coming out of opposite fitting The right hand tilt...
  • B
    bsamot69 replied to the thread L4400 fel not working.
    So that cylinder has some kind of defect, yes? I will perform this ritual on the other cylinders
  • B
    bsamot69 replied to the thread L4400 fel not working.
    For shits and giggles, in case the cylinder seals are bad, I checked with the nearby Kubota dealers. At the mention of Ansung.. "we...
  • B
    bsamot69 replied to the thread L4400 fel not working.
    First, the rod does not fully retract . It moves about halfway and stops. That is when the air comes out opposite end. You want me...
  • B
    bsamot69 replied to the thread L4400 fel not working.
    The rod retracts and air comes out of opposite end
  • B
    bsamot69 replied to the thread L4400 fel not working.
    Yes, that is what I did on each cylinder and air came out opposite fitting
  • B
    bsamot69 replied to the thread L4400 fel not working.
    All 4 cylinders have air come out opposite fitting.
  • B
    bsamot69 replied to the thread L4400 fel not working.
    Also, I tightened the caps and the loader does not bleed down .
  • B
    bsamot69 replied to the thread L4400 fel not working.
    Capped With the rod end capped off, the loader raised slowly. It lowered slowly after raising . It did not raise all the way.
  • B
    bsamot69 replied to the thread L4400 fel not working.
    I can pick up some fittings from a place in town.
  • B
    bsamot69 replied to the thread L4400 fel not working.
    I'll be digging up some kind of cap for a while:)
Show older items
Top Bottom