85Hokie's latest activity
-
I use a backup camera when I use my tree sheer. I had the same problem with vision. -
85Hokie replied to the thread Purchasing a 2005 BX2350 to replace a 1988 7200 4x4.I have a BX1850 with the FEL and MMM. Runs and operates perfectly. ONLY ONE DOWN SIDE ----------- PLASTIC fenders, hood . The sun...
-
85Hokie replied to the thread Bill of Sale 1969 Ford 3000.Yeah that may be true - but a farmer friend of mine always reminded me ..........cars and trucks are money wasters ....... a tractor is...
-
85Hokie replied to the thread 1998 b1700.As Russell said - check that clutch safety switch - I had the same problem on one of my B7100's
-
Yes you can usually bypass the switches. On my L185 there is one for the clutch that is a simple plunger that is open when pedal is up...
-
I wouldn't attach much importance to whether the loader is on or off. You're only looking at the difference in volume of the oil from...
-
Ok. Sounds like I do not have an issue. Thank you.
-
85Hokie replied to the thread M7060 Idle is high. How adjust?.Has IT always been there? OR has it gone up over time? Looking it up - that is spot on btw
-
85Hokie replied to the thread Dynamo and belt install bx2230.This may help: belt https://www.amazon.com/WQSING-16883-97010-266-107-Compatible-BX25DLB/dp/B0BT9JJF8N
-
-
85Hokie replied to the thread Forgot To Connect The Return Line, BX25.As we say down south - "you overcooked your grits!" I would chance oil and filter as soon as possible. That heat may or may not have...
-
85Hokie reacted to Kennyd4110's post in the thread Forgot To Connect The Return Line, BX25 with
Like.
But...that fluid was most likely pretty darn HOT, so you might think about a hydro service in the near future. -
I think since it is corrodEd on that water connection point, AND it is not charging you might be better off replacing it if you can find...
-
85Hokie replied to the thread Kubota B6000 charging problem.I am guessing here , but the pulley on the crank is a bit bigger than the dyno pulley - so at high idle I would say 2500 rpms would be a...
-
85Hokie replied to the thread Kubota B6000 charging problem.no...that would be bad. TYPICALLY dynos are bullet proof - did you try combos of the wires?
-
85Hokie replied to the thread Kubota B6000 charging problem.To check your dyno - If you have it off, place in a vise and use a drill and socket to spin it, otherwise place on the belt and have the...
