I am new here and find this site to be filled with valuable knowledge and well-versed members that know these orange machines quite well. I have a 2024 SVL 97-2 skid steer that had an engine compartment fire that burned all the components that were non metalic to a crisp. All the DPF components, wires, EGR, oil separator, etc.. This tractor is used on my farm and was planning on doing away with all DEF and DPF equipment. In their place I will install commercially available software and hardware that tricks the ECU into believing that all is well with the DPF. My question I have is what software will work to program the new ECM that will work with the new injectors, common rail sensors and new EGR valve. What software might work to get this thing to startup and run. Please let me know where I should look. Thank You for any ideas you might have.
Software needed for my SVL 97-2
- Thread starter Overmountain Man
- Start date
whitetiger
Moderator
Staff member
Equipment
Kubota tech..BX2370, RCK60, B7100HST, RTV900 w plow, Ford 1100 FWA
No software other than Diagmaster or KOBD Ace will program the Kubota ECM.
Dealers are forbidden from servicing a deleted machine.
Dealers are forbidden from servicing a deleted machine.
North Idaho Wolfman
Moderator
Staff member
Lifetime Member
Equipment
L3450DT-GST, Woods FEL, B7100 HSD, FEL, 60" SB, 743 Bobcat with V2203, and more
Yea like @whitetiger said, your going to be in a real pickle because Kubota is not allowed to program a deleted unit.
whitetiger
Moderator
Staff member
Equipment
Kubota tech..BX2370, RCK60, B7100HST, RTV900 w plow, Ford 1100 FWA
Russell King
Well-known member
Lifetime Member
Equipment
L185F, Modern Ag Competitor 4’ shredder, Rhino tiller, rear dirt scoop
North Idaho Wolfman
Moderator
Staff member
Lifetime Member
Equipment
L3450DT-GST, Woods FEL, B7100 HSD, FEL, 60" SB, 743 Bobcat with V2203, and more
Not very likely, as there are quite a few interface components that come into play.
Yeah I guess I will have to buy the software to do it myself. It is my understanding that if the machine is being used on a farm and not for contracting or commercial use you dont have to have the DPF system working. Anybody know about this? So regular Diagmaster will work to program and map the injectors and everything else? Its also my understanding that the ECU cannot be benched programed. Thanks for the help.
well software is out of the question. Not sure what to do to get this thing running. Please let me know if someone can add to this thread and thank you to all that contributed thus far
You could contact Reimer Tuning in Canada. They might be able to help you.
Tractor & Heavy Construction Machinery Tuning Experts In Canada
Reimer Tuning is a renowned Agriculture Equipment, Heavy Construction Machinery, and tractor tuning specialist in Canada offering quality tune services. Call now!
reimertuning.com
whitetiger
Moderator
Staff member
Equipment
Kubota tech..BX2370, RCK60, B7100HST, RTV900 w plow, Ford 1100 FWA