RCR 2672

[Dennis Akehurst]

how to change the seals in the gear box

 

[lugbolt]

take the old one out, put the new one in

 

[Mitjam]

how to change the seals in the gear box

Make sure you drain gear oil first. Some have plug on bottom others you will have to remove the whole top and extract the oil out. Depending if it’s the input or output seal? obviously makes a huge difference in what needs to be removed

 

[Mitjam]

Make sure you drain gear oil first. Some have plug on bottom others you will have to remove the whole top and extract the oil out. Depending if it’s the input or output seal? obviously makes a huge difference in what needs to be removed

If you doing both remove pto and then remove blades and blade carrier underneath, then the gearbox you can take to your bench to work on, much easier than trying to do the output shaft underneath the mower and safer too

 

[Dennis Akehurst]

thank you but do I have to disassemble the gear box to replace the output seal?
The seal guard looks to be smaller than the splines?