New clutch wont release

[Skintraditions]

Hey guys a newbie here i got a question about a kubota b6100e
I just installed a new clutch ,pressure plate, throughout bearing and pilot bearing. Got it back together and the clutch will not release. The same problem as before but the throughout bearing was making a noise so I replaced everything. I need help tracking down the problem. I've adjusted it every which way even a Lil tight I can press the peddle till the clutch fork rod hits the inner bell housing .
Could the clutch fork be wore if so how can I tell and where could I find a replacement

 

[North Idaho Wolfman]

Or it could be in backwards.

 

[Mountainman]

Had a customer with same issue. Verified everything was correct and adjusted correctly. Ended up being a crack in the clutch fork couldn't see it in the tractor.

 

[North Idaho Wolfman]

Other reasons that could be why is not working.
If the Flywheel has been turned.
Bad pressure plate
Disk bad (too thick)
Wrong parts
Flywheel or disk or pressure plate got or had any moisture on it when assembled.
I did one that once and dew settled on it overnight, put it together, set for a couple days then was stuck hard, had to disassemble and clean it up.
Clutch fork worn, broken, or installed backwards.

 

[Skintraditions]

Or it could be in backwards.

I looked at the print out from kubota and it in right