Deck PTO stalls B2100 when let out clutch

[PJD62]

Hello, recently got on my B2100 to mow. Runs and drives fine, but when I engaged the mid PTO and let out clutch it stalls engine. Safety switch is bypassed, and rear PTO works fine. Any ideas?

 

[TheOldHokie]

Hello, recently got on my B2100 to mow. Runs and drives fine, but when I engaged the mid PTO and let out clutch it stalls engine. Safety switch is bypassed, and rear PTO works fine. Any ideas?

Lift the deck and rotate the blades by hand. If they won't move the blades or gearbox is jammed.

Dan

 

[PJD62]

Lift the deck and rotate the blades by hand. If they won't move the blades or gearbox is jammed.

Dan

Blades spin free

 

[Fishhook]

The instructions say to raise the deck, increase the RPM and then engage the mowing deck. What RPM are you engaging the PTO for the deck?

 

[Tire Biter]

It’s gotta be in the safety circuit. You say the switch is bypassed, but did you wring out that circuit to see if it open somewhere?

 

[PJD62]

Blades spin free

 

[whitetiger]

Blades spin free

With the engine OFF, Mid PTO engaged, clutch pedal depressed, can you turn the blades freely in both directions?

 

[PJD62]

It’s gotta be in the safety circuit. You say the switch is bypassed, but did you wring out that circuit to see if it open somewhere?

Safety switch bypassed, also wouldn't start if it wasnt.

 

[PJD62]

With the engine OFF, Mid PTO engaged, clutch pedal depressed, can you turn the blades freely in both directions?

wasn't.
I will check and get back on this