As indicated to me by one of the more learned on this forum the American equivalent to my (Australian tractor L1-275DT) is your L4310. Can any one verify if the illuminated tail light assy on the rear fenders of the L4310 will fit over/on the rear fenders of a L3450. The reason being I want to convert from the current reflector type module to an illuminated lamp type so I can travel on a public road (legally). Any advice would be appreciated. Thanks.
Change of tail lights from L4310 to a L3450
- Thread starter beech35
- Start date
North Idaho Wolfman
Moderator
Staff member
Lifetime Member
Equipment
L3450DT-GST, Woods FEL, B7100 HSD, FEL, 60" SB, 743 Bobcat with V2203, and more
Kevin,
I'm not real sure if they would fit or not?
They do look very close.
My signals (rounds) are on top of the fenders with the reflectors still in place.
Looking at those it would be nice and clean to convert mine.
I'm not real sure if they would fit or not?
They do look very close.
My signals (rounds) are on top of the fenders with the reflectors still in place.
Looking at those it would be nice and clean to convert mine.
G'day North Idaho Wolfman, I am taking some measurements of the rear fender of my L-275DT where the existing tail light reflectors are to see if the L4310 tail lamps will fit - that would then give some idea if they would fit your equivalent of my L1-275DT. Let me know if you are interested in the measurements. Cheers Kevin (Australia)
North Idaho Wolfman
Moderator
Staff member
Lifetime Member
Equipment
L3450DT-GST, Woods FEL, B7100 HSD, FEL, 60" SB, 743 Bobcat with V2203, and more
North Idaho Wolfman, herewith pics showing fender measurements of my L1-275DT comparable to your L3450. Measurements are (1) 3" (2) 4 & 1/4" and (3) 9"" . How do the measurements compare to your fender measurements - it might give a starting point as to whether the 4310 tail lamps might fit both our tractors. Cheers Kevin (Australia)
