Hi All,
I've been working on restoring an old B9200D tractor for several months now and pretty well have it back together now.
Last night I started it up in neutral with the clutch pedal pushed and everything was looking good. When I went to put it into gear, the gears just grind as if the clutch isn't being pushed at all.
I tried shutting it off and putting it in gear first... then push the clutch and turn the key and it lurches just as if the clutch were not pushed.
I tried adjusting the clutch stop bolt all the way in (so the clutch would push in further to disengage) and still no luck.
This is the manual transmission 2 clutch model for the transmission and PTO.
Any ideas ? it's almost like something came off inside the clutch and isn't disengaging it. I can look from underneath and see the push bearing moving towards the engine when you push the pedal.
I have the service manual and checked that all the adjustments for the pedal were in spec, but still no luck.
Any help would be appreciated.
Thanks,
--Phil
I've been working on restoring an old B9200D tractor for several months now and pretty well have it back together now.
Last night I started it up in neutral with the clutch pedal pushed and everything was looking good. When I went to put it into gear, the gears just grind as if the clutch isn't being pushed at all.
I tried shutting it off and putting it in gear first... then push the clutch and turn the key and it lurches just as if the clutch were not pushed.
I tried adjusting the clutch stop bolt all the way in (so the clutch would push in further to disengage) and still no luck.
This is the manual transmission 2 clutch model for the transmission and PTO.
Any ideas ? it's almost like something came off inside the clutch and isn't disengaging it. I can look from underneath and see the push bearing moving towards the engine when you push the pedal.
I have the service manual and checked that all the adjustments for the pedal were in spec, but still no luck.
Any help would be appreciated.
Thanks,
--Phil