Search results

Good idea, not sure I could have done that and it fit. Radio reception not great as compared to car. Guessing it’s the radio.

Radio came with wiring diagram so I cut off old connector and put new connector on. The phone holder is held in place with two small bolts. I drilled holes in metal plate. If i were to add another hydraulic remote it could be in the way

There may be a low oil pressure engine cut off sensor.

Change radio out for a Blue Tooth model and install a new generic antenna. Remove cigarette lighter and replaced with a USB with voltage meter. Installed phone holder. Also put a cup holder with a push pin in the bottom, drink keep falling out on hills. Took a few hours but make working withe...

Three point hitch lift rod ends wore with lots of play on Kubota M6800. OEM part $$. The female and stud end are both 6mmx1.0 coarse threads. Can order 4 generic for half the price of the OEM.

A wire system is hard to install, getting wire ran in head liner. Running power and wire to head liner not hard.

Added a hydraulic top link to the Kubota M6800. Simple installation only needed hex wrench and metric wrench.

Good ideas, mounting monitor today

Thanks, that’s my back up plan. I already have one. I wanted to do wire into the fuse box if I can figure out how to do it.

Yep, that’s it

Brand is Rohenk from Amazon, checked spare fuse holder in fuse box, not connected. Going to unmount fuse box and see if I can connect in back. If not have an adapter to split a fuse connection. Thank You

Don’t know but if you order through Amazon Prime , it’s free returns on product so nothing to lose other than some time. Good luck

Windshield washer container broke and had to replace. Factory container is $$, purchased one online $20. Electrical connector is the same only had to add a view inches to hose. KEMIMOTO Universal Car Windshield Washer Pump, Washer Fluid Reservoir Bottle Kit with Pump Jet Button Switch 12V...

Thanks for the reply, my system is wired. Going to mount higher to get a viewing angle to see forks and 3 point hitch attachments. Started looking at how to wire and it appears that there is spare fuse holders. I have not hooked up volt meter to see if they work. How did you hook in the system?

Hello, first post: Going to add a camera system to a M6800. It has a front and back camera. Looking at the manual cables run up the post of the cab on the fuel tank side. Will mount monitor on the dash and run the cables down the column, up the cab post, remove head liner and dril holes in the...