Looking to buy a backhoe subframe or one that is close to fitting a kubota b8200.
I dont mind having to modify one a little bit to make it fit.
I a located in Greene, NY 13778 i am willing to drive around 3 hours to come pick it up.
Had to use my tractor last night so I swapped the pb and out line. 3 point hitch works as it should now. But when I raise my loader it's a little jerky and the tractor little bit of a winding noise. It did not do those things when the lines were wrong. I check the fluid according to the dip...
The front of the tractor has kind of like a tube cut in half where the loader slides in to it. The back is the only spot where there is a clamp system to hold it in place. I am in no way a tractor expert this is my first tractor. I can fix just about what ever is in front of me. But knowing...
The owner before me had it set up with couplers so he could remove the loader system. The loader has a kind of quick removal setup. There is 2 swing away u bolts 1 on each side. You can remove 1 nut on each side and the the ubolts swing away. Prop up the loader disconnect the lines and back up.
There is quick couplers I think the owner before me got the lines crossed. As for the backhoe just going to use it for around the house projects. Septic system for my moms camper. 500 gallon tank and 1 leech line. Going to go about 4 foot deep and around 50 to 60 feet long. Hard to pass up a...
I just got a L-4530B backhoe attachment. So after I switch the PB and B lines. I should still run the PB line to the in Port on the backhoe then run the out line back to the B port according to my pictures correct?
I have a b8200 with a bush hog 1845-qt loader. When I set my 3 point hitch height the only way I can get it to raise is by operating my loader. Once the 3 point hitch get to desired height it will stay there until I change the height.