Search results

I agree, and I’ve had other machines where those switches have caused problems. Haven’t solved the issue yet, but will keep digging. Thanks

Yes, it acts just like a safety switch opening. Definitely could be a wiring issue per Lugbolt above. I appreciate everyone's input!

Yes, I had changed the fuel filters, but it wouldn't hurt to do it again, especially if there's a good bit of trash in there. I will definitely go through all the wiring, given the starter and also a non functioning fuel gauge on the left tank I hadn't mentioned.

I have a used zd326 I recently picked up at auction. It does have issues starting, and I read a related post in the forum, and I will try those suggestions. After I do get it started, the machine runs fine, and cuts fine. I was cutting for about 2 hours and wanted to take a break. I...

It definitely seems to small to mess with at this point. I did not see any evidence of oil sprayed on the fan belt like you did, so I'd maybe rule out a pulley oil seal. The only concerning thing is that the machine is a relatively young 750 hrs. A technician at the dealership suspects the...

Hey Everyone- I was following your post Woodsy in an attempt to troubleshoot an oil leak of my own. I just purchased a used MX5100 with a moderate oil leak showing up at or around the front axle pivot. Per Kabotafreak, the oil could be the original UDT in the axle bypassing an oring or seal...

Appreciate your input friend!

I’ve read posts regarding oil leaks on the front axle pivot possibly due to o rings going bad. In my case, the oil seems dark and lighter than the 80w/90, but I could be wrong. Is there any chance this could be coming from the engine? From what I can tell, I don’t see any evidence of leaking oil...