Search results

I have a L5240 equipped with the mid PTO kit to run a front snow blower. The thing has started leaking. Not losing a lot of oil but enough to make a helluva mess on my shop floor. The seal is available and I'm trying to decide whether to replace it or continue to live with the mess. Is there...

I use this tractor with a 60" mid mower. This spring it's started shutting down frequently. Suspicious of fuel that was in the tank all winter, I drained it all, ran the fuel through a water separating filter, put some of it back in the tank along with some fresh fuel and changed the fuel...

My neighbor has an old, well worn B1750. The steering was getting awfully sloppy and it was pushing hydraulic fluid up through the steering column. They decided to try to get it repaired. We don't have any dealers in the area that I'd be confident would repair it without putting more $$ in it...

I'd like to install Mini LED rear work lights. Kubota makes a "kit" (#T1065-75370) that's a switch for them. I don't know what else is in the "kit". Does anyone have any experience with this "kit". I have the WSM and the wiring diagram shows wire running back above the headliner to each side...

Do any of you Pirahna users have any experience roughing up or breaking up ice with it? I have a 1/2 mile gravel lane that winds up and down and through timber. I clear snow with a L5240 with a front mounted blower. But, of course, there's always an inch or so that thaws, refreezes and makes...

The shaft in the belt tensioner hasn't taken grease in the 3 years I've had it. So I decided I better address it before it froze up, if it wasn't already. I got the spring off and found that it apparently was getting adequate lubrication. Now I gotta get the d---ed thing hooked back up. At 78yrs...

I'm considering adding a rear remote to facilitate an hydraulic top link. I have one on my L5240 and I couldn't get along without it. I'm trying to move some of my "chores" over to the smaller B7610 tractor. It's small enough to be more suitable for close work around the buildings. Is there out...

Does the B7610 have a vent somewhere on the front axle case? If so, can you tell me where it is. Mine will force some oil out around the seal after running it for a few hours. Sitting, it doesn't leak. I rather not replace the seal, but if there's no vent, a seal change is probably in my future.

Does anyone out there have the RCK60-24B on a B7610? I have 2 B7610s and have had the deck on both tractors. I just can't get it set so that the front of the deck will lift as high as it should in the front on either tractor. The manual says the distance between the front stopper and the mid...

I have a minor but irritating oil leak. It's allowing oil into the bell housing and out through the starter. If I were younger I'd tackle it myself, but it's out of the question now. Does anyone know roughly how many shop hours are involved in splitting it and putting it back together? There's a...

Did Kubota sell a loader specifically for this model? There's one in our area with a loader, but I'd like to know if it was a Kubota item or an aftermarket one before I proceed.

Want to check rod bearings on a B7610. Can I drop the pan without splitting the tractor?

How is the engine hung in this tractor? Is it mounted sitting on rubber bushings like an auto engine? It looks to me that it may be bolted directly with bolts going into the side of the block. I recently bought second B7610 sight unseen. The price was right and it had only 205 hours on it. Got...

At 800 hours, I'm due to check valve clearances. Opened the service manual and I can't get past step one. Where is the port to see the TDC mark? Is it buried behind the support post for the loader? If so, Which side? Hope I don't have to remove the post to access it.