Search results

Finally got the 3pt log splitter hooked up to my new L3901. I had been running it on the old B7200DT and it was full of some pretty nasty oil which had to be flushed before I connected it up to the new machine. About $60 worth of SUDT2 down the drain.... The continuous flow rear remote outlets...

When I purchased my L3901 this summer I was aghast at the cost of factory rear remotes and disappointed in the cut-rate outlet kits that came with them so I set out to build a better mouse trap. Here is what I have come up with so far. The panel is a simple bolt on installation using the...

Went to grease the LA525 loader today and discovered the retaining cap screws in both lower bucket pins were MIA. This has all of the hallmarks of a chronic issue. The ends of the screws stick out on the bottom side just begging for the nut to be caught and snapped off when grading with the...

I am ready to pull the trigger on a grapple for my new L3901 and I like almost everything about the 60" RG-7 from MTL a lot. My only concern and it is not great is the weight. At 520# that is about twice the weight of the 66" bucket and eating into the payload a bit. I have the loader manual...

I debated R1's vs R4's when buying this L3901 but its mainly mowing and landscaping so I ultimately decided on the R4's. I was pleased by how the performed on this grading job They negotiate the grade with no problem and they tracked the fill in nicely.

Just took delivery of a L3901 with LA525 loader and loaded R4s. Its clear it needs more ballast. Looking for wheel weight recommendations from folks that have put them on their tractor - OEM or after market sources. And yes - rear wheel weights - not alternative solutions. Dan