Search results

Thanks! Will do. thanks I check all those fuses and all is good. Gave them a visual inspection then a meter test as I have had fuses that looked good but were bad in the pasr On a wiring diagram I saw an inline fusible link. Not sure if my tractor has one of those.

C Cranked fine but would not run

Crabked cranked but no start up

Did that. It would not fire or run.

Yes. Checked each fuse with meter rather than relying on visual. Had a spare 50 amp so put it in.

W What is “OPC”?

I have an HST. Error 20 explaination reads out odd. Does the HST pedal need to be in neutral to start the engine?

Where is the ECU?

I started a new thread to emphasis a new question. I have a new battery with 13.6 volts, new cables and ends, all fuses are good. Ordered new safety switches for clutch pedal, PTO and HST pedal sensor. Seat switch is OK. I am now searching out the other possible culprits using using the...

To test switches can I bypass them with a jumper wire or paper clip?

OBTY. The immediate issue started when I ran it out of diesel on a very steep hill. It cranked by key a bit to prime engine but never fired.

The tractor incident “history” is included in the initial post. the depress clutch message comes onto the screen when you hit the starter key. The massage shows up where it states ERROR-20 in the attached photo. The depress clutch message flashes into the screen then disappears

I called that one switch the parking brake dog in error. It is most likely the HST Pedal Sensor.

Thank you for the wiring diagram. Mine is the HST model. I found a couple safety switches (eg, the PTO and parking brake dog) that were worn out. No continuity even when depressed. I will buy new ones and t I checked for voltage at all the safety switch plugs after removing them and all...

I jumped it at the switch but still no fire or start up I will take your advice and start at the PTO switch and work around to all the others. Thanks

I did jump the switch’s plug with a bare wire and it still would not start when turning the starter over by jumper at solenoid with key on.

I am going to go through all the safety switches as you did.

I checked all, all good.

M My clutch pedal assembly was bent by a tree branch intrusion a few years ago. I bent it back with a pry bar and sledge hammer. It worked passable all this time. But I will test it electronically when reinstalled to be sure.

I tested the clutch switch and it had continuity when depressed. Not sure where to look next.