L2350dt retrofitting a BL4690b backhoe

[fox2boost]

thanks for all the replies! i have to do some measuring and figure out what my best option is...

 

[Flintknapper]

There you go. Are you sure it will clear the drawbar and top link bracket?

Dan

About 14" to work with that direction, before needing to use a PTO extension to move it all outward.

 

[Donystoy]

Here is the bracket that I made to hold my pumps. One on my splitter and the other on my BH. I can adjust the nuts on top so that there is minimal downward weight on the pto extension. The upper part of the bracket has a sleeve that uses the lower pin location of the 3ph bracket. The guard around the pto also has to be removed. My BH is a BH77 that I converted from tractor hydraulics to pto driven. I used a 6.8 gpm pump that was readily available.

 

[Flintknapper]

Here is the bracket that I made to hold my pumps. One on my splitter and the other on my BH. I can adjust the nuts on top so that there is minimal downward weight on the pto extension. The upper part of the bracket has a sleeve that uses the lower pin location of the 3ph bracket. The guard around the pto also has to be removed. My BH is a BH77 that I converted from tractor hydraulics to pto driven. I used a 6.8 gpm pump that was readily available.

VERY nice. Excellent work.