Recent content by newshb_k

Hi everyone, seems I lost my clutch adjustment bolt, anybody knows the thread size of the bolt? Part number is 66711-13320 I am asking since in my country there it could be hard to find b7100 parts, and I don’t want to order just a bolt from overseas 😂

Yes, I assembled it facing wrong way…I am not sure I got mislead by a video of disassembly where it was laying down, so I assembled it also laying down 😂…glad I didn’t move the tractor as the rear gear could got broken by the cylinder

I have removed the 3 points hitch and found the piston in the oil 😅 seems I assembled it incorrectly now issue is fixed Thx everyone

I I have checked and it is tight,,,I suspected it could be the piston, and when I opened the cover I didn’t see the piston, is this normal

I will check that part no, I didn’t change the o-rings on the filter….but one thing to mention is that after I assembled the tractor again, the hitch worked fine but was stuck at the top…once I applied wait it dropped and never raised again

Thx for the reply what could be the cause of not having the flow, the pump? I have changed the oil and assured the level is ok….

Hi everyone I have split the tractor to change the reverse gear, and I changed the hydraulic oil, and cleaned the hydraulic filter. After assembling the tractor, the three point hitch raised and didn’t lower. So I applied some weight on it to lower it, and suddenly it became loose and doesn’t...

I will go the welding route; since I was able to split the tractor, with the hydraulic line is still in the rear part (since I wasn’t able to remove the filter). I will take the gearbox to weld shop to weld a suitable nut and hopefully I will be able to remove it

I believe the hex size is 26;

It is #3 I have attached a picture of the nut.

The S/N of the tractor is B7001-71659

yeah, I will tear it down completely to inspect everything for the filter/strainer, it is the hex stripped

Sure tomorrow once I complete the stripping, but I believe it is the same gear Marty changed in his gearbox restoration video in YouTube

Thanks for the reply. I can ship from USA or other country, am not sure about the part number tomorrow will have picture for the stripped filter nut

Hi all Hope all is doing well and having amazing year start I have some noise when do I g reverse in my B7100 (non HST), and expected some worn gear in the gear box today was my first attempt ever in tractor split, all went well except I was unable to remove the hydraulic filter (bottom of...