loggin's latest activity
-
LIt's 100", so it must be a BH9x Thanks for the help in identifying it... ;)
-
Lloggin replied to the thread Backhoe control bracket cracked into.Thanks for letting us know! The next indicator is the boom. I believe the BH90 has a straight boom and the BH92 has a curved one. I have...
-
Lloggin replied to the thread Backhoe control bracket cracked into.Which backhoe do you have?
-
Lloggin replied to the thread MX6000 noise after warm..Umm.. I am trying to understand this. Perhaps you could explain how turning off an injector would help to warm up an engine? Also I...
-
Lloggin replied to the thread Gf1800 crank no start.Unless you are very familiar with injection pumps I would not suggest taking it apart, rather remove it and bring it to a good injection...
-
Lloggin replied to the thread Gf1800 crank no start.There should not be any bubbles coming out at the injector lines. Might indicate trouble with the injection pump. I'm assuming you...
-
Lloggin replied to the thread Hydraulic Pipe Pulled out.If the above model is incorrect you will have to put in the right one.. Wasn't sure if it is HST model or not.
-
Lloggin replied to the thread Hydraulic Pipe Pulled out.Looks like might be inlet line..?? Here is a link to Messicks I believe it is part # 70 in the parts diagram. Hope this helps...
-
Lloggin replied to the thread 2019 MX5800 HST PTO not engaging.I believe the shop manuals have wiring diagrams in them, or at least they used to. You could ask the dealer to confirm that.
-
Lloggin replied to the thread 2019 MX5800 HST PTO not engaging.Yeah, unfortunately I get a little lost with these new tractors that have computers in them. Only other thing I can think of is if there...
-
Lloggin replied to the thread 2019 MX5800 HST PTO not engaging.I would suspect one of the safety switches is suspect. Did you have pressure on the seat when you checked for power at the pto solenoid?
-
LTo be clear, when i did the work on the cylinder it was disassembled, oil removed, cleaned with soap and water and brake cleaner. I...
-
Lloggin replied to the thread Leak at cylinder fitting.Personally I would remove the rod as well just to be on the safe side. Not sure what the flash point of the hydraulic fluid is but if...
-
Lloggin replied to the thread Hydrolic problems on KX71-3.My guess is that maybe some water got into electronics for the controls..? You say it started after you washed the machine.
-
Lloggin replied to the thread Leak at cylinder fitting.I believe that port is at the closed end of the cylinder. As long as the rod is in the extended position there shouldn't be any seals in...
