Firstgear's latest activity
-
F2700
-
Fon a Kubota 3560 what engine RPM equates to 540 PTO RPM?
-
FFirstgear reacted to armylifer's post in the thread How to repair a cut in R4 Tire Tread ??? with
Like.
Here is what to do when the tear gets really bad. -
FFirstgear replied to the thread L3560 pricing question.I bought a new L3560 LE and I am really glad I did, you can’t beat a cab with heat and a/c. Get the radio, its just too good.
-
FMy tractors are always stored inside my barn. Recently, we had minus 28 F degrees here at my location. Many years ago after acquiring a...
-
FFirstgear reacted to RichardAaronlx2610's post in the thread Tipped over and backhoe stuck in the down position with Like.
Dang, any pics?
-
FFirstgear reacted to D.jFarm78's post in the thread Tipped over and backhoe stuck in the down position with Like.
A couple years ago the neighbor had a bh with the arm down. We broke the lines loose and lifted with another tractor. If other equipment...
-
FJacking up the rear is not a real problem - assuming you are using a floor jack and stand. I typically raise it about 1/4" of the floor
-
FWhere do you place a floor jack to jack up the rear of L3560? Do I jack it up at the draw bar mount area?
-
FFirstgear reacted to bbxlr8's post in the thread What do you have for a stump grinder and would you buy it again? with Like.
Another +1 for the WG24 - used it hard & fast initially and very happy with the results vs value. I am ok spinning around and careful...
-
FFirstgear reacted to NCL4701's post in the thread What do you have for a stump grinder and would you buy it again? with Like.
Woodland Mills WG24. Have ground a few dozen stumps with it. For my use, yes I would buy it again. It’s basically a stump grinder wheel...
-
FFirstgear posted the thread What do you have for a stump grinder and would you buy it again? in Implements & Attachments.or would you buy something else and why?
-
FFirstgear reacted to North Idaho Wolfman's post in the thread Need help on what I need to add for PTO stump grinder hydraulic controls for my L3560 with Like.
Go to a Kubota dealer and go to the sales department and tell them that you need to add two remotes to your tractor, they can supply you...
-
FFirstgear posted the thread Need help on what I need to add for PTO stump grinder hydraulic controls for my L3560 in Implements & Attachments.This is the type stump grinder I am considering...
-
FFirstgear reacted to DustyRusty's post in the thread Kubota Transmission Filter & Fluid Change with Like.
Because I have a Kubota BX 22 that when the oil was changed at 50 hours, it was clear just like the oil that went in. I have helped...