Got a B21. Seems to be a "screw and jam nut" adjustment for hydraulic pressure.
I was going to cobble up a pressure test rig that I would plug into the backhoe supply, "in series", so the BH could still operate, if I chose to do so.
The test rig would be a simple "T fitting", a 3000 psi gauge, a male and female quick coupler on each end.
Seems this would be the least "dangerous" and most likely to give an accurate reading.
Thoughts?
I was going to cobble up a pressure test rig that I would plug into the backhoe supply, "in series", so the BH could still operate, if I chose to do so.
The test rig would be a simple "T fitting", a 3000 psi gauge, a male and female quick coupler on each end.
Seems this would be the least "dangerous" and most likely to give an accurate reading.
Thoughts?