Radio plug schematic B2650HSDC

[Torrin]

Good morning;

now that the inevitable happened and the Lions got their butts kicked, I need a schematic of the radio plug in for the B2650HSDC Headliner. I have pulled the radio slot cover and have the white nine pin male plug and the antenna plug accessible. I found on EBay a female plug to allow aftermarket radios to work, but I do not have a schematic or connection list of the male plug. can anyone help

 

[85Hokie]

Good morning;

now that the inevitable happened and the Lions got their butts kicked, I need a schematic of the radio plug in for the B2650HSDC Headliner. I have pulled the radio slot cover and have the white nine pin male plug and the antenna plug accessible. I found on EBay a female plug to allow aftermarket radios to work, but I do not have a schematic or connection list of the male plug. can anyone help

can you take a "good" picture of the wires that are on this connector?

depending on the colors of these wires, 2 sets will be for speakers, a red for hot, a black for ground, perhaps a another color for dimmer, and a few more for any other reason they wanted to use........

I picture will help immensely.

here is a swag....

http://knowledge.sonicelectronix.co...-installation/wiring-harness-color-standards/

 

[Torrin]

Thanks Hokie

That is what I needed. Now I can get a good radio

 

[85Hokie]

Thanks Hokie

That is what I needed. Now I can get a good radio

The radio that you get - unless you are looking for something very specific - a simple pioneer/kenwood/jvc/etc - they will all do fine!

I would imagine that your tractor has two speakers? ALL of these will output to 4 - but can be used with two. THEN again maybe you dont have any speakers?

http://www.crutchfield.com/g_300/All-Car-Stereos.html?tp=5684&pg=1

 

[PHPaul]

The schematic in my WSM shows the following for the radio plug:

Gr/G to 5A Radio fuse on fuse block
L/R to Right Speaker +
R/L to Right Speaker -
V/Y to Left Speaker +
Br/B to Left Speaker -
Y to 15A Radio,Room Lamp fuse on fuse block

I couldn't find a table to decode the color abbreviations, hopefully it's obvious.

 

[bearbait]

I know it's been a while but just have a few questions. Is there any chance a 6.5" speaker will fit even if not in the original speaker openings. The reason why I ask is I have some infinity and rockford fosgate component 6.5 speakers. If not how do the 4" speakers sound. The stereo I just ordered has bluetooth and usb so I was thinking that maybe bluetooth headphones or earbuds would be a good alternative to the 4" speakers. Either way it's time for the stock equipment to go.

 

[Bevan175]

Hope this helps

 

[bearbait]

Hope this helps

Thanks very much. I managed to get it done last week, the easiest stereo I ever installed. I bought a Pioneer stereo and the wires were the same colour as the kubota stereo