Piranha Bar or ?

[Bulldog]

Might try what I did if you want to save some money. I bought teeth for a Kubota 4672 backhoe. It takes a little time to drill the bucket but it's not that bad. I have no plans to remove them but do have the option if needed. I think they were about $27 or so each. They are quality teeth from what I can tell. They are still like new and I've had them for several years now.

 

[D2Cat]

I picked up a tooth bar that had the heels torched off of the teeth at the salvage yard for $25.

In about an hour I cut off the ends and shortened it to fit a 5' bucket. The ends are in a couple of inches further then I would like, but it works fine. I welded some where the torch had cut the heel, and made the tooth long enough to snag the lip of the bucket just fine.

 

[D2Cat]

Couple more pictures.

The second picture shows the tooth I removed setting between the end of the bar and the tooth that was there that I left there. It was of no use to have two teeth so close together, so I left the gap.

The last picture shows where the tooth was cut off of previous application and what I needed to get engagement to my bucket.

 

[Husker]

good info...