The clutch on my kubota is on the way out. I’ve only had the tractor 6 months.
It won’t drive in any of the high range gears anymore. It does move in low range a bit but doesn’t like to do much work before the clutch slips.
I notice there isn’t much free play in the pedal. I know spec calls for 1” of free travel. (I can’t actually adjust the pedal because the front loader brackets are in the way.)
the tractor only has 700 hours on the clock. is it wishful thinking that it might just need an adjustment to the pedal…?
if i split the tractor can anyone advise which parts should be replaced while I’m in there:
clutch disk
Pressure plate
Throw out bearing
Clutch housing gasket
Pilot bearing?
Many thanks in advance.
It won’t drive in any of the high range gears anymore. It does move in low range a bit but doesn’t like to do much work before the clutch slips.
I notice there isn’t much free play in the pedal. I know spec calls for 1” of free travel. (I can’t actually adjust the pedal because the front loader brackets are in the way.)
the tractor only has 700 hours on the clock. is it wishful thinking that it might just need an adjustment to the pedal…?
if i split the tractor can anyone advise which parts should be replaced while I’m in there:
clutch disk
Pressure plate
Throw out bearing
Clutch housing gasket
Pilot bearing?
Many thanks in advance.