hello, I was using my b7100 today and seem to have lost my float on the loader. I was wondering if I have to replace it, what the hose fittings would be so I wouldn't have to use adapters. Thanks in advance
B219 loader valve fittings
- Thread starter Grizzlybear
- Start date
North Idaho Wolfman
Moderator
Staff member
Lifetime Member
Equipment
L3450DT-GST, Woods FEL, B7100 HSD, FEL, 60" SB, 743 Bobcat with V2203, and more
Float is the easiest part of the valve to repair.
I wouldn't think you will need to replace it.
It could be just frozen.
I wouldn't think you will need to replace it.
It could be just frozen.
Thanks for the reply, if I push the lever all the way forward, sometimes it will float the bucket but most times it will lift the front tires off the ground. You have to work the lever numerous times to get it to float
North Idaho Wolfman
Moderator
Staff member
Lifetime Member
Equipment
L3450DT-GST, Woods FEL, B7100 HSD, FEL, 60" SB, 743 Bobcat with V2203, and more
Read this thread and it should help!
http://www.orangetractortalks.com/forums/showthread.php?t=12971
http://www.orangetractortalks.com/forums/showthread.php?t=12971
Yup, most likely you just have rusty/corroded balls, detent balls that is. Dissasemble the end cap, clean it out, fill will grease, and drill a small drain hole to allow moisture to escape and you will be good as new.