7 shank ripper

[JLMullins]

Does anyone know how to install a shank on a ripper? The springs are quiet large and was wondering if anyone had a good way to install? Thanks in advance.



Thanks,
Jimmy

New To Tractor in 2014
Last used 1979 before military career.

 

[North Idaho Wolfman]

Picture of what your working on would help, there are a lot of ways they are attached to different models.
Name and model # would help too!

 

[JLMullins]

Picture of what your working on would help, there are a lot of ways they are attached to different models.
Name and model # would help too!

It basically looks like this but no paint I don't know the make or model. The center shank is off and I need to get it back on.

Thanks
https://encrypted-tbn1.gstatic.com/...xF7FYGZ2-4lQt8rrbLiUGe1IO8H_B7lTpP380i59bz0MQ

 

[JLMullins]

It basically looks like this but no paint I don't know the make or model. The center shank is off and I need to get it back on.

Thanks
https://encrypted-tbn1.gstatic.com/...xF7FYGZ2-4lQt8rrbLiUGe1IO8H_B7lTpP380i59bz0MQ

http://cdn3.volusion.com/wf72e.9ho5t/v/vspfiles/photos/FC-Field-Cultivator-CAIN-7-2T.jpg

 

[JLMullins]

http://cdn3.volusion.com/wf72e.9ho5t/v/vspfiles/photos/FC-Field-Cultivator-CAIN-7-2T.jpg

http://cdn3.volusion.com/wf72e.9ho5t/v/vspfiles/photos/FC-Field-Cultivator-CAIN-7-6T.jpg

 

[JLMullins]

Sorry new to this.

 

[North Idaho Wolfman]

Is it putting the springs back on the pins that your having a hard time with?
If it is you can use a piece of pipe fit it through the spring and the end of the pipe over the pin pulling the spring onto the pin, put a little grease on the pipe so the spring slides easy.

 

[JLMullins]

Thank you, just needing a little help here and there.

Jimmy

Yes it is putting the spring back on and stretching it to the installation knob.