Zl1501 4x4

Rickybobby609

New member
Feb 6, 2020
11
0
1
C.M.C.H. New Jersey. US
I just got a brush hog and was using it yesterday but whenever I tried shifting into gear when the pto was engaged it would grind but no grinding or anything and it shifts fine without the pto on any ideas?
 

North Idaho Wolfman

Moderator
Staff member
Lifetime Member

Equipment
L3450DT-GST, Woods FEL, B7100 HSD, FEL, 60" SB, 743 Bobcat with V2203, and more
Jun 9, 2013
28,306
4,856
113
Sandpoint, ID
I just got a brush hog and was using it yesterday but whenever I tried shifting into gear when the pto was engaged it would grind but no grinding or anything and it shifts fine without the pto on any ideas?
Have you put an overrunning clutch on it?

If not then there is your issue, your PTO is driving the backside of the Transmission gears. ;)
 

Rickybobby609

New member
Feb 6, 2020
11
0
1
C.M.C.H. New Jersey. US
I’m not sure what kind of clutch is in it I’m assuming whatever was in it from the factory I haven’t touched the clutch except to adjust the pedal when I first got it is there anyway I can tell what kind of clutch is in it?
 

Rickybobby609

New member
Feb 6, 2020
11
0
1
C.M.C.H. New Jersey. US
Could I just get an overrun clutch to go on the end of the pto shaft and use that even if it does have an internal one? I just don’t want to have to pull this thing all apart but I need it working right for this weekend