Just bought a 2003 Kubota L3130 tractor and need to remove the turn signal switch in order to remove the dash. I'm sure it's simple but I'm at a loss. Anyone have experience with this that can offer advice? Thanks in advance!!
Kubota L3130 Turn Signal Switch
- Thread starter Joray31032
- Start date
Daren Todd
Well-known member
Lifetime Member
Equipment
Massey Ferguson 1825E, Kubota Z121S, Box blade, Rotary Cutter
Some times the knob pulls off and then there is a nut that holds it on. Others hook to the face with a nut on the back side. Post a pic of it and someone can probably tell you
Thanks Daren. Here's a photo of the switch. If it's a nut on the back side, I'm not seeing it and it'll be a bear to get to 
Attachments
BAP
Well-known member
Lifetime Member
Equipment
2012 Kubota 2920, 60MMM, FEL, BH65 48" Bush Hog, 60"Backblade, B2782B Snowblower
Look for a little screw on the side of the knob. Also, the center on the top may come off to access a screw holding it on.
Thanks BAP, couldn't find a screw and the center would separate from the switch, so got brave and just pulled straight up. Seems it just snapped on, but you had to put some pressure on it for it to snap off. Thanks again for your and Daren's assistance.