1994 B7100 HST 4x4, new model. Serial series 71380. 1344 hours, but the meter hasn't worked in years. I have been reading the archives and think I am more confused now than before.
When depressing, what I assume is the clutch to engage the mid mount mower, there is a noise, like something vibrating. When I release the pedal, it is quite like normal. Bake in my 64 Chevy, that was indicative of a throwout bearing. When I try to engage the mower, the mid mount PTO for the mower deck grinds a little bit before going into gear. Not seriously grinding but not slipping right in. I would like to correct this before it gets any worse.
Reading the forums I have found some replies stating there is no clutch on a hydrostatic transmission and others saying there is. There certainly is what seems to be a clutch on the left side that is used for a starting safety switch and to engage the mid and rear pto.
I read about greasing the grease fitting in the hole on the left side under the tool box, and will do this when I go back to the farm Thursday.
Clarification would be appreciated on what you think the problem is. Worn out clutch?
Is there a complete kit kit available to overhaul the clutch, pressure plate etc... or do I order parts individually. 66905-13300 I believe is the clutch according to my parts manual.
When depressing, what I assume is the clutch to engage the mid mount mower, there is a noise, like something vibrating. When I release the pedal, it is quite like normal. Bake in my 64 Chevy, that was indicative of a throwout bearing. When I try to engage the mower, the mid mount PTO for the mower deck grinds a little bit before going into gear. Not seriously grinding but not slipping right in. I would like to correct this before it gets any worse.
Reading the forums I have found some replies stating there is no clutch on a hydrostatic transmission and others saying there is. There certainly is what seems to be a clutch on the left side that is used for a starting safety switch and to engage the mid and rear pto.
I read about greasing the grease fitting in the hole on the left side under the tool box, and will do this when I go back to the farm Thursday.
Clarification would be appreciated on what you think the problem is. Worn out clutch?
Is there a complete kit kit available to overhaul the clutch, pressure plate etc... or do I order parts individually. 66905-13300 I believe is the clutch according to my parts manual.