Search results

No, it’s in there about 12-14”. Looked but I seem to can only get 12” metal blades… if the penetrating oil doesn’t work I am looking at drilling it out.☹️

No leaks visible I tested the dipper cylinder per the above test procedure and it was shooting oil past the piston seal. i was trying to get the boomcylinder out to unhook the hose but I am having major issues with that. The pin in the boom is seized. It is actually seized inside the cylinder...

Hi All, my backhoe boom and dipper both drop to ground when not actively held up with a control input in 10-20 seconds Thought two leaking internal cylinders but resisted the urged to buy 2 new seal kits and instead ask for help to properly diagnose this. The bucket and swing seem to work fine...

I guess there is a centering position but it doesn’t come out up automatically Should I leave it in center?

Yes, there’s a pump slipped onto the pto shaft. Backhoe is giving me some issues also, it I’ll start a new thread for that! Thanks again!

I already learned a lot by this excercise!

well don’t I feel stupid! That what you get when you get you buy a machine and know nothing about it’s workings! Thank you guys so much!! That’s all it was…..

I ordered it

the hoe is mounted and working “from 2“ goes to “to 2” in the other picture. The upper one on the tractor I don’t really different noise when nothing is moved or when the boom or bucket get to end of it’s travel.

I ordered a gaug, couple days and I should have it no rear remotes just the hoe

Yes the bucket works normally the 3PH is just powering the hoe, and it works. the issue occurs both with the PTO not engaged and engaged

It’s in the up setting. guy I got it from saidhe always left it there. But didn’t know much about it either

Right, I just figured that out looking at the schematics. Very confusing to follow. It looks like the hoses are right because with help from another input it ends up working in the direction it’s supposed to. So I have to open it up and check if I can find anything inside the valve body? What if...

Valve location

Here are they

Yes, because of a burst line I replaced two. But the issue was happening before. I actually bought the thing with the issue.

It boggles my mind because I thought both circuits were separate loops

Hi all, My LA 302 loader boom will not lower without using the float function. it will only lower without using the detent when I am curling the bucket up or down. As soon as the bucket is curled completely the boom will stop. same thing raising the boom under load. It will only go up while...