Search results

I still need it. Thanks for the offer

I would like to convert to a non-Auto return setup. remove solenoids and add manual linkage. Is there a kit or known part number?

Thanks; They didn't have any in stock. They are looking to see if they can pull one.

Front Axle Hub Part number H6710-56833 (replaced 67121-56833) Anyone parting out an old B20 B8200 B9200 B2150

Got it! Thanks for the suggestions. I used a tie-rod fork and was able to get it to clear the top of the bevel shaft.

Thanks, the bearing is still intact. I am trying to get pull the entire bearing out the top of the case.

B20 4x4 HST The bevel gear is item 60 in the second illustration . It goes through 70 and 10 on the first illustration. The top bearing is item 90 in the second illustration. In order to remove the bevel gear the service manual states, 1: Remove bevel support cover (not Illustrated, holds...

Thanks, Yes the end cap came off. Yes it appears to be just a rolled lip that retains the end cap. Do you have any advise for fixing the rolled lip after end cap is re-assembled? I need both solenoid to operate. The swing function is controlled electronically even if AR is not used.

Thanks, I am going to attempt replacing the seals (#420). The solenoid end cap came off, assuming a blown seal over pressurized it.

Sorry I should of said. replace the electronic control.

Replace the electrically controlled swing section with a manual control and linkage.

I assume the linkage is attached to some kind of potentiometer to send signal to solenoid based on lever movement. ( I could be misunderstanding the circuit as well).

I will have to see if these parts are still available. I would also consider a after market assemble.

There is a sensor on the swing arm. Based on where you set home the controller will auto swing the bucket back to home position. It uses the solenoids to activate the valve, I wouldn't trust hooking up a different valve in the current controller to operate as expected.

I have an old B20 with a BT750AR backhoe (http://www.tractordata.com/backhoe-loader/000/1/3/130-kubota-b20.html). The backhoe has a auto return feature which is electronical controlled. One of the electrical solenoids (yellow) came apart. I am not sure if the solenoid is the failure point or...

Has anyone successfully used an alternative control valve assembly on a BT750AR (78621-63010)? I would like to eliminate the auto return function and use an all manual control valve assembly.

Thanks Lugbolt; Sounds like a weld option is possible but may not be preferred. I will try to find a replacement case. Any insight as to the difficulty level of the R&R? Any specialty tool required?