Search results

What is the difference, and which one would be better for a grapple and a hydraulic chute cylinder on a Kubota BX22?

Looking for wheel spacers for my BX22. Primarily looking for a set for the rear, but will also consider front spacers if you have either or both. Looking for a little more stability on the slopes. Please advise size, price, and shipping costs to 01550 by least expensive method. Thanks Dusty

I just checked next years cost for Medicare Part D, that is the cost of prescription insurance. My cost went from $32 a month to $65, and the deductible increased from $435 to $465. Co-pays have also gone up almost double. When you check the fine print, they also have excluded the payment of...

At my old house, I used a 1' length of 1/2" pvc pipe and solvent welded on a male threaded coupling. Drove that into the ground level with the grass and then in the fall, I would screw a 4' length of pvc pipe with a female coupling on the end onto that. After the first year, I learned that I had...

I have both hydraulic turning and chute deflection on my front mounted Kubota snow blower, and the turning function is controlled by the loader joy stick. I had a separate valve for operating the deflector, however, that valve somehow got misplaced. I would like to use just the loaders dump...

I have a BX22 with loaded tires in the rear. I also have wheel weight from an older tractor that will bolt onto the Kubota wheels. Is it acceptable to use these weights in both front and rear for additional stability? thanks

I have to take the floor pan off of my BX22 to get to the piston for the 3 point hitch, and replace the seal. I have everything loose, but I can't see how to remove the knob from the 3 point hitch adjustment rod that is directly under the seat, and how does the mower deck height adjustment knob...

Let me start with saying that this isn't to lay blame to the previous owner, but as a lesson as to what happens when a few set screws are not tightened enough or parts are assembled incorrectly. Even the assembled incorrectly might be a result of a factory assembler not doing his job correctly...

On my BX22, the loader valve has to come off with the loader because it is attached to the right hand loader upright. If you want to use it for the snow blower, snow plow, or sweeper, you have to first remove it from the loader, and reconnect it to the tractor. Kubota changed this with the...

My tractor came with Super UDT from the factory (2004). My 5 gallon bucket is getting low, and now I see that they are selling Super UDT2.. What is the difference? thanks

I am looking for the female half of the driveline that mounts on the snow blower, and connects to the rectangular shaft that is on the tractor quick hitch. Also the female side of the quick hitch that is mounted on the rear of the snow blower.

Which direction do the shoes get mounted? I have seen pictures of them pointing toward the rear of the tractor, and others, where the shoes are pointed forward, and are under the snowblower. What is the correct orientation? thanks

Just wondering how many people have a cab on their tractor. I went without one for about 3 years, and finally decided that winter is too cold on my old bones not to have a cab. I bought a soft sided Curtis Cab that fits a BX2200, and mounted it on my BX22. Also bought the cab heater at the...

Last winter, I used a piece of wire coat hanger to check the condition of the gear lube in my snow blowers gear box. What I found was that the oil had turned grey. I was thinking that the gears were shot, or a bad bearing, but figured that I would get to fixing it in the warmer weather...

Took my back hoe off my BX22 today, and installed the 3 point hitch. The arms will lift and lower, but as soon as I put the weight box onto the lower arms, the tractor was unable to lift the weight box. Never had a problem like this before. Both the loader and the backhoe were working fine prior...