Search results

I use a split length of 1 1/2" abs pipe on the cutting edge at the beginning of the winter season until I get a good base.

Apparently there is a new E (emission) version of the 905D

I just discovered Kubota has enlarged the block heater for the BX2370, the new models are 5mm larger with more space around the element and it protrudes into the block a little farther but that doesn't help me unless I ream out the frost plug hole to accept the larger heater.

The heated seat cushion straps over the seat. I only have the need for the low setting when it's really cold out and I do have a cab on the tractor with a coolant heater.

I purchased this 12 volt unit from Amazon several years ago for $20 and it has held up really well. It plugs into the 12 volt receptacle at the base of the seat on my BX. They no longer have a link to it from my purchase history but I'm sure it would still be available.

I started out without a timer until the second one burnt out then installed a timer, on for twenty five minutes off for five and also installed an ammeter so I could see when it wasn't working. Now I have reduced the wattage to half and removed the timer. I want to leave it on for an hour , the...

Getting tired of replacing block heaters on my bx2370, bought a new one and rewired it to work at 200 watts instead of 400 watts. Maybe I'll get more than two seasons out of it now.

I use this one, bought from Harbor Freight. transfer pump. battery powered transfer pump. a - Temu Canada Attaches to a 5 gallon fuel container. I rewired it to work on a 3 volt adapter and it really works well.

Remove the fuel line from the tank to the first filter and check the flow. These lines get plugged up at the tank and can be cleared by blowing compressed air back into the tank with the fuel cap loose. The filter fills up with fuel slowly and when you start it everything works until the fuel...

My tank gets filled in a garage and the fuel is run through a screened funnel. The tractor was used when I purchased it so it either happened then or it has developed a fungus from the fuel. What ever it was I blew it back into the tank with compressed air, the line was completely plugged. I...

I just dealt with a blockage in my fuel tank (bx2370) , time for an access panel on top of the tank.

When I changed the filter on my bx2370 I lost a few drops, next to nothing.

If the fuses are proper, the wire gauge is proper for the required current then likely a bad connection that heated up.

Did it blow any fuses?

What is the amperage draw for the heater and fan and what fuse is connected to it?

Take it to a body shop or search plastic welding on Youtube and buy a kit to weld it.

Loader Install- BX2380 Tractor: Know Your Kubota (youtube.com)

I can hear the pump but barely. It starts and runs fine until it warms up, say an hour or more of running then it starts to stall out. Leave it sit and it runs fine again. I'll get into it when it warms up, snowing today.

I'm experiencing the same symptoms with a bx2370, I have a feeling it's the fuel pump, haven't tested anything or looked inside the tank yet.

I have the same problem, let the tractor sit twenty minutes and it runs fine again. Fuel tank is full and I screen the fuel so I doubt if it's dirt or water. Machine is stored in a non heated garage. I'll let the fuel run down and drain the tank and have a look inside the tank with a camera but...