Search results

Crank journal is smaller

Got the grill for a b8200. Has a crack.

Replacing pistons in V1902 engine out of a L3350. Using plastic-gauge I find one crank journal to connecting rod bearing to be almost twice the WSM spec (.003. VS .006). I find specs for minimum clearance but not maximum limit. The crank is still in the engine and I just pulled the oil pan...

I have a la680 with mounting brackets near Philadelphia

Engine, trans and drive train sold. Still have hood and side panel. Also have cowl with steering wheel and attached parts. Selling cheaply

Update I removed the oil pan and only found aluminum flakes (pic). Proceeded to unbolt and remove pistons. The #4 piston was broken just below top ring. I would say that is the cause of the blowby. Now to confusing issue; all 4 rod bearings were scored and #1 was spun. The #1 connecting rod...

No one indicated that they had dropped the oil pan without separating the engine. I have almost accomplished it. The front axle and front axle bracket had to be removed. Now ready to unbolt the 60 lb oil pan. Lots of work. Pics attached

I had located the two from flywheel housing. Also there are two bolts coming from front axle direction

Outstanding reply and I thank you

I need to replace piston/rings without separating the tractor. I am thinking that someone has removed the oil pan and replaced pistons. I have done this on other L series tractors but this appears challenging. To start the oil pan weighs about 54 pounds which will require a lift/jack. It...

Sorry I don’t. Have the hood and side pan el in sheet metal

Engine and drive train sold. Will list parts later

Finally determined how to hookup the arms. If any interest I can post a pic

Need help for attaching arms to support loader. I have a set of two arms but cannot determine where or how they attach to loader. Appears BF800 support arms are different from other L series tractor. BTW tractor is L3350

I have mis-understood your question about backhoe. I have not attached a backhoe but on my other tract the backhoe brackets attach to the FEL brackets.

It rolls easily and I have fel to load the La680 fel

There are no brackets for backhoe. Lots of parts interchangeable between L3600 and L4200

Major components: Good 40 hp ENGINE, 4 cylinder V2203, new head/high compression, complete with hydraulic/injector pumps, alternator, etc, Complete GLIDE SHIFT TRANS, Hydraulic steering, 3 pt controller, ROPS, Front LOADER LA 680 and subframe, hood and side panel sheet metal, lots of miscelleous...

Location

I am told that LA853 will also fit the L4330