Search results

Bad Day Monday Did the compression test. One cylinder was essentially zero. Since the head was just rebuilt, the issue is probably the piston rings....could also be cylinder liner or broken piston. This is the cylinder that part of the glow plug fell into. No unusual noise during cranking...

Now I am worried about the compression. I did not check it after I put the refurbished head back on. I will check it this afternoon if it stops raining

Re: L35 Timing Window and Not Starting Unfortunately, I do not know the history of the tractor. So I do not know if any of the fuel components have been removed. The tractor would not start when I bought it. The glow plugs were shorted to the head. When I removed them, part of one glow plug...

The L35 will not fire up. I was thinking that it must be timing. Battery is new, compression is about 300, new valves, seatd, etc. fluid at the injectors. Tested injectors when rebuilt head. All safety switches relays were removed, straight wire to starter and glow plugs. Glow plugs tested...

I cannot find the window to view the timing marks Does the starter have to be removed? WSM useless.

L45 in PA is a scam

Where to start? Guessing brakes are locked or damage to gears in the Differential. Don’t know history and tractor does not run. Trans levers move freely. Any inspection ports or tests before taking it apart?

BT900 or BT1000

Re: Broken Hydraulic Filter Housing on B8200HST Thanks 100TD for your reply. The arms will fall down after the engine is off for some time. When the engine starts the arms come full up. The lever on the control valve has no effect. Lots of force will not move the arms down. FEL works...

I have replaced the HST filter bracket and filter. I have not started the tractor because I am waiting for pressure gauges and fittings to check the HST pressure. I doubled checked the hydraulic plumbing and it is correct. This over-pressurization is a repeat event for the tractor (not for...

I have been working on the 3-point controller for the B8200HST. Re-installed the controller and started the engine. When I raised the lever full up, the filter was pressurized and broke the male fitting that goes into the filter. This filter is down stream of the controller and before the...

WTB a hydraulic filter housing for a Kubota B8200HST. Part #66301-37810

The last two are perfect. Thank you so much!

It's the rod between the control valve and the RH lift arm. Need pic of how it's connected to the control valve. It is connected to the lever opposite the main control lever

SRG Pls send me a pic of the end of the feedback bar that attaches to the controller arm. I need to make one for my B8200 Wayne

Re: Interim report on 3-point hydraulic refresh Dave, Thanks...

Re: 3pt Stuck in Up Position on B8200 UPDATE Hey Wolfman I moved the feedback lever in every combination with the control lever. I am glad that the piston can be eliminated from my problem. Thanks Since you thought it could be the feedback lever, it is connected to the spool 1 through the...

Re: 3pt Stuck in Up Position on B8200 UPDATE I removed the control valve from the tractor. When I removed the front cover, I found that the lever spoon between the control lever and the feedback rod was disconnected from tumbler spool 2. After many tries, finally got the lever spoon connected...

Re: Interim report on 3-point hydraulic refresh Hey Roll and all, I have been working on my 3pt valve (See my post for details). The lift arms always go to the up position and stay there. Is there suppose to be any resistance on the lift arms when I move them with the engine off? There is...

You did an amazing modification. I really appreciate your pics. Just a couple of questions. Was the mover the correct model to fit the tractor w/o the FEL? In hindsight, would it have be easier just to remove the FEL? Thanks for your reply...I really appreciate it.