Search results

i have repeatedly visited the dealer near winnipeg on order to buy a RTV 500 virtually none available in the country just want plastic roof and a front bumper anybody know of one anywhere ??? Tia

Im considering the purchase of the RTV 500 Good machine for the money ???? is there a WSM for this ? Anything special to watch out for ?? Thanks in advance for any advice Vic

the engine will stop if you get off the seat when pto-blades are engaged disengage the pto and you can get off engine will continue to run good luck

i just went thru this stuff with my L3300 turns out corrosion on cables and posts cleaned posts and new positive clamp applied silicone dielectric grease put on works as new Mandatory to have no corrosion

cylinders and hoses - replace them- a lot less money than a new machine etc consider aftermarket products and compare to Kubota $$$$ you will see what i mean

i used brush on my floor mainly because the factory mat would not stay attached works well for me L3300

i haven L3300 and a 6' allied blower they have worked very well together for many years all types of snow condition

my friend uses my 5' king cutter on his small tractor with very good results

mt L3300 has a 2 step clutch throttle to idle clutch pedal inn engage pto lever slowly release clutch pto shaft turns be in neutral release clutch all the way select speed gear increase rpm to 540 drop 3point hitch and go do the job 5' king cutter works every time for me

HELP i want to buy gator blades 3 18.7 inches to fit on GF1800 2wd asap where can i buy them TIA im in canada but im sure they can be shipped the local Kubota guy cant find them in his available stock system

tractor supply has a " big bale mover" inexpensive and works well - put in 3ph lift a bit drive to bale lower the lift reverse under bale lift and place it in selected spot lower the lift drive away done deal go get another one

If you bought one at nearest peavey used it on your site -- you could rent yourself and machine out for a few $$$$$ recoup some coin

maybe just try a key from the same model # from a friend or ??? i think that here the keys are not done for individual tractors 1 model y fits all model y

along I29 ????

you might try a wheel company they may be able to fix the wheel itself or be able to supply a matching wheel good luck

you are close enough to Dauphin and can rent 3ph equipment or better yet ask a nearby farmer to help you with the tasks btw you cant grow kulbasa

quit messing with the little guys move up to an L3000 series. it will do more work than you can imagine

L3300 very good machine, circulating heater put on it years ago when -20s plug it in starts right away when not quite so cold and no plug in glow plugs x2 starts quickly let it run to warm up.. as I read on this forum start let it run have a coffee then another cup then go to work...

if you want to cut grass then buy a riding mower front mounts work well an L series tractor is capable of MOST attachments

the plug on the top is the FILL hole the lower plug on the side is the level indicator remove both plugs fill from the top- when oil comes out the bottom hole STOP it is full thats what I was taught and it works for me