Search results

Hitch Category.... Top Link Pin Diameter... Lower Link Pin Diameter........ Lift Arm Spread (A)......... Vertical Height (B) 0...................... 5/8".......................... 5/8".................................. 20" 1...................... 3/4"...

Is this drawing similar to what you are referring to? SWINGING DRAWBAR ASSY. 8N http://tractorshack.com/catalog/product_info.php?cPath=44&products_id=374&osCsid=9728f23e36ca154559f1d8e2343edf6e

Does anyone have more insight on the capabilities, uses, or problems with the M9540 tractor? I am posting again to see if anyone has any fresh insight about this posting! I would greatly appreciate any and all feedback. Thanks for your input!!

It seems that every time the fields were plowed rocks of various sizes popped to the surface. Some of the rocks were large enough that the disk would have to roll over them. Would it be advantageous to have a cultivator to initially work the ground after plowing or will a disk work okay for the...

I have not received my owners manual yet - the dealer is a little slow with providing that. My reference was to the difference between PTO and Draw Bar horse power - it seems that the older specifications for tractors listed engine HP and Draw Bar HP and now they list engine HP and PTO HP. The...

My M9540 is 4 Wheel Drive. I have searched the internet about moldboard plows and according to the general consensus a tractor should be able to handle about 1" of plow per drawbar hp, but it seems that most forums indicate that they use much less plow than that. According to the formula 5...

I am going to be attempting to start working my fields to reseed alfalfa. The soil is fairly light and sandy with quite a few small rocks and a few larger rocks. I recently purchased a used 2007 M9540. I have never worked fields with a larger tractor(only worked fields when I was younger with 8N...

If it does it in all gears, check the shift lever where it bolts to the linkage in the cab. E/S It does it in all six gears. Any tips on what I need to disassemble to get to the linkage in the cab?

I recently purchased a 2007 M9540 and have noticed that the gear shifting 1-6 (range H - L works well) seems to be rather loose and sloppy. Sometimes I have released the clutch and only heard gears spinning - no movement. Is the shifting on this tractor normally rather loose and if not is there...

I recently purchased a used 2007 M9540 from a John Deere dealer and have not received the Operators manual yet. The tractor was originally purchased in Canada. I am not familiar with diesel engines. I have tried a few different ignition positions and get no indication that the glow plugs are...