Search results

My L3301 sounds about the same, too. That's how it was from day one and up to 80 hours so far.

My neighbors are cows on one side, trees on all other sides. Down my road, the nearest people are about 3/4 mile. I can't remember why I ever liked living in a subdivision...

I haven't see the outside, but I'm not sure it goes all the way through. It was looser today, maybe just letting the rust penetrant sit and work helped. I was going to use the crescent wrench to rotate it to where I could try the bolt trick but just turning it a couple times with the wrench...

Nothing big today, just moved some leaves around for a burn pile, then moved some tools around. Load the bucket & drive around is a lot easier than hauling them all over multiple trips...

Yeah, Hughes is high latency - because the satellite is 25,000 miles above the surface, it's a 100,000 mile round trip for the signal to go there, back to the ground, and then back - that's more than half a second at lightspeed. This happens for each connection - so when you load a website with...

Yeah I used the antiseize too, but I guess I just left the attachment on too long. Going to try again tomorrow.

Thanks for the diagram, that helps to be clear what we're discussing. Pin 030 is rotated a bit over 90-degrees ccw, you can see the bolt hole near the end if you look closely. I like your suggestion, the only difficulty being that the pin is rotated far enough that the bold wouldn't push...

I'm trying to remove the three-point hitch to attach my backhoe, but one of the pins seems to have gotten stuck - rust perhaps? I used some WD-40 rust release (much like liquid wrench) and managed to get it to move a little, but now I can't move it any farther. Brute force isn't working simply...

I was just trying to figure out what happened to a couple posts I made! Thanks for the update. If you would like help with any of the technical side of things, that's what I do for a living, so happy to contribute what I can.

I have a Land Pride grading scraper - one of these: https://www.landpride.com/products/dirtworking/grading-scrapers Got it with the tractor, because I had never owned anything like this before and it was simpler to use for my main purpose of road maintenance. I know there's advantages to a box...

A couple days ago, I got the thing running again thanks to advice from you guys here! Now I have wires that need to be reconnected :) Looks like that's this weekend's project.

Just for my own education: So this tractor doesn't have a lever that controls the position? I realize they're different, just trying to understand that difference: my 3301 has a lever with a bunch of numbers, I can position that lever for various heights. From what I'm reading, this 2380...

Checking my manual, (L3301 / L3901) it specifies Kubota Super UDT-2. Manual 2wd - 28L / 7.4gal Manual 4wd - 28.5L / 7.5gal HST - 23.5L / 6.2gal

I knew there had to be another part of the system I didn't know about - it was the HST switch! Thanks for the help!

Seat switch yes, HST no - I'll give that a try next, thanks!

Battery is new (less than a month), all the connections were cleaned when it was installed. Keep in mind that it was running and shut off when I got up - exactly like it should do if the PTO is engaged. "Check you PTO selector" - That's the switch I'm bypassing. It IS set correctly and I've...

Hello, all - just found this forum while looking for info on my problem, hoping someone can help! The problem is: my L3301 (HST) won't crank. Power goes on but when I turn the key to start, nothing happens. No clicks, nothing. It stopped suddenly when I got off. I had the problem before and...