BAP's latest activity
-
BAP replied to the thread Mid Mount Mower blades.On my B2920, I use the loader and a chain to pick the mower up and then use my impact wrench to remove the blades. With the impact... -
BAP replied to the thread Dipping toes in the world of Welding.Another thing to consider, if you are going to be welding outside or working on old rusty equipment, a stick welder will perform better...
-
Sheeting/ Decking pretty much done. Wrap tomorrow, metal next week.
-
BAP replied to the thread Dipping toes in the world of Welding.Before spending money on a machine, find a way to try your hand at welding. Whether it be a neighbor that lets you try or taking a class...
-
Just went threw this with JD {Mother Deere}. Little back ground. I had looked around over the winter about up dating our combine. Long...
-
BAP replied to the thread HST pressure tester?.You seem bent on going right to buying expensive diagnostic equipment without doing the simple stuff first. Check clutch and changing...
-
I remove the loader, it only takes a minute to do so.
-
BAP replied to the thread B7500 Engine Issues, Dies & Surges.Did you make sure that the fuel tank cap is venting properly?
-
BAP replied to the thread Paint falling off.Those aren’t front mounted snowblowers. The OP specifically asked about front mounted snowblower if you read his post thoroughly. RAD...
-
It is probably chlorophyll from the vegetation you were mowing, it will not hurt a thing.
-
BAP replied to the thread M4900 Hydraulic Problems. Power steering, PTO are OK. Everything else weak.Then how do the hundreds of thousands farm tractors with planters and mowers with single action lift cylinders and dual valves work...
-
BAP replied to the thread M4900 Hydraulic Problems. Power steering, PTO are OK. Everything else weak.Are you making sure that your hydraulic remote control lever is returning to neutral position after raising or lowering your mower? With...
-
BAP replied to the thread Quick Hitch for L3902, W68 Chipper and FM-62 Flair.It would be easier to advise if we knew what you have for a tractor? Quick hitch for a BX is different than a hitch for a M8 series...
-
BAP replied to the thread Who Made My Blade?.Could be an Oliver or something sold by Oliver if the paint is original. Has some characteristics similar to Dearborn Danuser blades...
