Newbie to the forum here. I recently inherited a L345DT that has been in the family since new. In the last few years it has been difficult to start when cold. Typically requires ether to fire off.
Seems to have significantly less power than before. Struggles in high gear. Has a difficult time running a 5’ bush hog.
Glow plugs are good. Has new fuel filter. I cleaned out the fuel tank last summer.
The machine has roughly 3k hours on it and does have a little blowby but not excessive.
What should I be looking at injectors, compression test, valve adjustment?
Also I don’t have a shop manual yet. Any recommendations?
Thank you in advance
Seems to have significantly less power than before. Struggles in high gear. Has a difficult time running a 5’ bush hog.
Glow plugs are good. Has new fuel filter. I cleaned out the fuel tank last summer.
The machine has roughly 3k hours on it and does have a little blowby but not excessive.
What should I be looking at injectors, compression test, valve adjustment?
Also I don’t have a shop manual yet. Any recommendations?
Thank you in advance