rear tail light connector to caab harness

[tinman4240]

I had to replace the left rear tail light assembly on my L4240 due to corrosion. During the process of separating the M/F plastic connector ,, which is up under fender where it can get constantly soaked and corroded,, I wrecked the 4 blade connector, The new assembly comes with a 6" 4 wire pigtail and the female half of the quick connect. I'm quite sure the only # on the new female is 816C21. Hoping someone may know who sells that specific connector. Kudos to the Kubota engineers for selecting such dry protected area.

 

[Mark_BX25D]

Can't help you with the correct connector, but you can always cut off both connectors and simply splice the wires together. Use .250 quick disconnects if you want to be able to disconnect easily in the future. Cut and splice one pair at a time so you don't get them crossed up

OR, you could just find a connector pair with the correct number of pins and use that.

McMaster-Carr

McMaster-Carr is the complete source for your plant with over 595,000 products. 98% of products ordered ship from stock and deliver same or next day.

www.mcmaster.com

McMaster-Carr

McMaster-Carr is the complete source for your plant with over 595,000 products. 98% of products ordered ship from stock and deliver same or next day.

www.mcmaster.com

McMaster-Carr

McMaster-Carr is the complete source for your plant with over 595,000 products. 98% of products ordered ship from stock and deliver same or next day.

www.mcmaster.com