L3350 front drive shaft

[David18902]

Hi. Looking for the front driveshaft (between transfer case and front axle) part # 32560-44290. It seems to not be available from kubota and shows up as discontinued through U.S., Canada, and Japan Kubota. Any ideas?

 

[North Idaho Wolfman]

West Kentucky Tractor Parts

http://wkytpstore.com/

 

[David18902]

Thx for the suggestion but no luck there...

 

[Lil Foot]

I googled "used kubota parts" :
https://www.google.com/#q=used+kubota+parts+

 

[rbargeron]

Hi. Looking for the front driveshaft (between transfer case and front axle) part # 32560-44290. It seems to not be available from kubota and shows up as discontinued through U.S., Canada, and Japan Kubota. Any ideas?

Has your shaft failed at the couplings? Post a picture? The tricky part is the splined end joints. A machine shop could make a new keyed shaft and modified couplings?

 

[North Idaho Wolfman]

When I look it up it shows it as still avalible?

Might be a long shot but try these:

http://www.colemanequip.com/parts/KubotaParts/32560-44290/

http://www.goldeneagledirect.com/index.php?l=product_detail&p=100427

http://www.tractorx.com/kubota-32560-44290-propeller-shaft-genuine-oem

 

[1970cs]

When I look it up it shows it as still avalible?

Might be a long shot but try these:

http://www.colemanequip.com/parts/KubotaParts/32560-44290/

http://www.goldeneagledirect.com/index.php?l=product_detail&p=100427

http://www.tractorx.com/kubota-32560-44290-propeller-shaft-genuine-oem

No sir it's no longer available! I checked all dealers in North America and all obsolete parts warehouses don't have it either!

Pat

 

[North Idaho Wolfman]

Thanks for checking Pat!

 

[DVoss]

It's not that hard to make one, if you have a sample to go by. The spline itself is the hard part. it's going to cost some money to have the splined hobbed on one piece. Then there's the connection slip joints....if they are like the L4150DT.

I'd be happy to make it....if you have a sample. But, it's going to cost some real money. Material, machining, heat treat.

 

[DVoss]

Just looked at the schematic at MBTractor...the shaft is very similar to the L4150. The couplers are available...maybe. I'd be inclined to make the shaft.....it would keep everything OEM.

 

[North Idaho Wolfman]

Just looked at the schematic at MBTractor...the shaft is very similar to the L4150.

That's because it is the same shaft.

David18902,

When looking for used parts all of these model tractors take the same shaft:
L3350, L3750, L4150, L4350.