L2501 front wheel drive lever not moving

[EchoYaKnow]

Hi! I've been trying to get my tractor into 4WD and haven't been able to get the lever to move at all. It has no give to it even when I follow the instructions in the manual and is stuck in the down position. Any tips for troubleshooting or how to solve this issue? Could be simple, but this is my first tractor.
Thank you

 

[jimh406]

Try putting it in neutral with the clutch in.

 

[old and tired]

I usually rock the steering wheel back and forth... Can you lift the front wheels off the ground with the front end loader?

Long shot but just in case, have you tried to move the level in the other direction, to make sure it's not already in 4x4?

 

[TheOldHokie]

Hi! I've been trying to get my tractor into 4WD and haven't been able to get the lever to move at all. It has no give to it even when I follow the instructions in the manual and is stuck in the down position. Any tips for troubleshooting or how to solve this issue? Could be simple, but this is my first tractor.
Thank you

My L3901 is very hard to shift. Seems to be the nature of the beast. Try using the loader to lift the front wheels off the ground.

Dan

 

[mdhughes]

I find that it is easier to get in and out of 4-wheel drive if you are rolling.

Is your L2501 a HST or DT?

 

[Runs With Scissors]

I thought mine was hard to move when it was new, but it seems to have "freed up".

I would try the above suggestions.

Is it a new machine?