Hello, just bought an old B7100D. Trucker lifted it down from front axel and 3-point lifter. Apparrently something went wrong, because hydraulic doesn't raise or lift anymore. it went down but that was all. There's no force, it's floppy. Any idea/knowledge what break there?
B7100D 3Pt Hitch Not Lowering or Raising
- Thread starter TommyDractor
- Start date
Are you saying it worked before being lifted onto your trailer? There is no down pressure so once the arms are down it will be floppy that part anyway is normal
Russell King
Well-known member
Lifetime Member
Equipment
L185F, Modern Ag Competitor 4’ shredder, Rhino tiller, rear dirt scoop
There is a rod from the 3 point piston to the shaft that rotates and lifts the small arms (rock shaft?) that is not really attached at either end.
I would assume that during the lifting process the arms were forced higher and that rod fell out of position. I think yo should also inspect the upper cover for cracks and breaks. I doubt the designer would think that someone would think lifting as you described would ever be done.
I would assume that during the lifting process the arms were forced higher and that rod fell out of position. I think yo should also inspect the upper cover for cracks and breaks. I doubt the designer would think that someone would think lifting as you described would ever be done.
North Idaho Wolfman
Moderator
Staff member
Lifetime Member
Equipment
L3450DT-GST, Woods FEL, B7100 HSD, FEL, 60" SB, 743 Bobcat with V2203, and more