Finally: Added a hydraulic block

Hello,

I found a neighbor who is really firm in farmer-equipment and has a lot of stuff to do hydraulics. I brought my Kuno to his place and we added a hydraulic block.

I wanted to have a joystick for two valves, just in case that I get the need for a FEL (green/blue). One is with swimming.
And I thought it would be a good idea, to have an additional stick, that can latch in position to power an hydraulic motor. This valve has the couplers at the front and back (yellow/red).
The pressurelimit is adjusted to 150bar/2175psi.

carl


Here are the pics:

Today I have received some hydraulic cylinders and couldn't wait to connect one to the traktor. I measured the time and calculated a flow of 7 l/min (1.85 gpm). The engine in my B1-15 (B1502DT) is a D850.

I really thought it would be more...

I plan to connect 2 cylinders for the small front lifter. These cylinders are 40/25 mm and 150 mm stroke. It will take 2 sec for lifting and 3 sec for down.
Regarding the pressure of 150 bar the cylinders will lift 2 tons and at the end's around 500kg (1:4). Push down 3 tons (750kg). With the ratio of 1:4 the lifting will be 600mm.
But I have no idea when I have the time to get it welded... I will make some pic's!

carl

cmorningstar01 said:

...mean looking tires...

Click to expand...

They are standart tires for the normal use in japan: muddy rice field's.
The tires at the back work quite well, but the front tires are often damage the lawn when I make a hard turn.

carl

ps: Yes, cable at the stick.