B7100 Clutch pedal has too much travel

kubby1972

New member

Equipment
Kubota B7100
Jan 30, 2015
2
0
0
roseville, MN USA
The clutch pedal on my B7100 has too much travel. Replacing the clutch disc, pressure plate and release bearing did not solve this problem. The pedal travel is too far with all the linkages adjusted. Any ideas?

Thanks
 

85Hokie

Moderator
Staff member
Lifetime Member

Equipment
BX-25D ,PTB. Under Armor, '90&'92-B7100HST's, '06 BX1850 FEL
Jul 13, 2013
10,345
2,167
113
Bedford - VA
The clutch pedal on my B7100 has too much travel. Replacing the clutch disc, pressure plate and release bearing did not solve this problem. The pedal travel is too far with all the linkages adjusted. Any ideas?

Thanks

Could there be anything bent in the linkage?

How much travel does the pedal have before it has any kind of resistance?

If the same problem was there before you replaced the internals, something has to be installed incorrectly :) orrrrr, something in the linkage is still out of whack.
 

kubby1972

New member

Equipment
Kubota B7100
Jan 30, 2015
2
0
0
roseville, MN USA
Well, the pedal goes all the way to the bottom before it barely engages. My friend who is a heavy truck mechanic just helped me split the tractor and we cannot see anything out of whack except that the release bearing sleeve that the fork rides on is showing some wear.
 

olthumpa

Active member
Lifetime Member

Equipment
L275
May 25, 2011
1,501
2
38
Maine
Well, the pedal goes all the way to the bottom before it barely engages. My friend who is a heavy truck mechanic just helped me split the tractor and we cannot see anything out of whack except that the release bearing sleeve that the fork rides on is showing some wear.
Did you get a Kubota clutch or an aftermarket clutch?
 

North Idaho Wolfman

Moderator
Staff member
Lifetime Member

Equipment
L3450DT-GST, Woods FEL, B7100 HSD, FEL, 60" SB, 743 Bobcat with V2203, and more
Jun 9, 2013
28,676
5,106
113
Sandpoint, ID
Go to Kubotabooks.com and download the three part service manual, it will tell you how to measure and set up the clutch.
I think olthumpa is eluding to the fact that aftermarket clutches can be setup and/or build out of specs, He had a heck of a bad run at this just a while ago, so it's something to watch for.
 

mickeyd

Active member
Lifetime Member

Equipment
2014 L3200 DT w/LA524 FEL, 2019 Kubota Z121S w/ 48" Pro Dec, TG1860G w/RCK54TG
Mar 21, 2014
1,192
17
38
Guin, AL
Welcome to the forum from Alabama.