Search results

Well I found a local shop that specializes in injectors and pumps. Pretty big outfit. Had several kubota pumps they were working on. Turns out two injectors were not producing much and the plunger was bad on the pump. Less than half of a new one to overhaul. Before there was no fuel coming out...

The magnetic filter sounds like a great idea for any diesel.....will try it, thanks

I have suspected a fuel problem since it was new. Only has about 300 hrs on it but has never had the power the old 900 did. Ran ok but had no ass to it. Could not even imagine putting a plow on it, so I guess I wanted to know for sure. Found a local shop that all they do are injectors and pumps...

Well sounds like your typical very simple complicated problem. What type of shops test the injectors and pumps. I know our local dealer doesn't do it. Thanks for the input:confused::confused:

Have a D1105 in a 1100 RTV that quits. Found sediment in the tank with some rust in the pickup. Cleaned the tank, changed the filter and the pump. Starts rough smooths out, run for 5 minutes and then dies. Will not do anything but idle. Bled the lines same thing all over again. Has never had...

Posted a reply yesterday but don’t know where it went! Anyway, never assume because it makes an ass out of …….so, in the beginning I replaced the battery, and cables. Turns out one of the new nicely molded battery cables were occasionally bad, but I ruled that out because it was new! Wrong...

Well, it can’t be that because it’s new and I just replaced it.....wrong, wrong. Intermittent new molded battery cables had me on a roll chasing 12V and then would lose it at the ignition switch, or a safety switch, or in a harness, only to get the volts back thinking ah ha found it, only to...

Thanks for the input, and yes the hair is thinning. I feel confident with a wiring diagram in hand but I do have a question. I have no juice anywhere. When jumped the starter does spin the engine. I have checked the saftey switches and they are all good. My question is this, if the operator...

Ed, thanks for the diagram, been looking for that

I have had no luck with this issue on my f2000. There has to be an inline fuse somewhere on this thing that I can't find. Any idea where I might find a wireing diagram? Its always the easy ones that drive you crazy. Battery, safety switches, ignition switch,cables, ground, all good. No power...

Have several kubota mowers and tractors but this has me stumped. Have an older f2000 front cut mower that is dead, electrically dead. New battery, found loose wire in the ignition so replaced the switch. Have 12v going to the starter, clean battery ends,checked all fuses, connections, safety...