Search results

no worries; tongue in cheek comment. Have been told that but don't want to invite more issues so wanting to make sure

Can't call you a smart arse as obviously you learn nothing from your experiences !

Front wheel came off when bearing collapsed. Replaced wheel bearings, greased them plus bevel gear,fitted seal and slid wheel hub back in. Wondering what stops the wheel hub from coming out. Is it the two collars shown on diagram? Can one improvise short term?

From the various helpful comments it seems that all roads lead to the starter relay ?

Obviously Outnumbered was not outsmarted :). Interesting that if I connect a battery charger for a couple of minutes it never fails to tart.

Thanks for the relevant info Dan / Dave. Will follow up and see what results.

Your contribution appreciated. Tractor works fine tractor runs fine. I'm betting on air in hydraulics given the abnormal noise . Will check intake lines sn d go from there

uncoupling all three hoses

only done couple of hours since fluid change and filter cleaned. Fluid level checked regularly and maintained to full mark. Previous have managed to release trapped air by disconnecting hydraulic hoses but not working this time

Kubota B 8200 not been used for couple of months Started and hydraulics worked fine; FEL & slasher. Short while using and stopped functioning, not moving at all. Hydraulics emitting noise.

Your assistance is appreciated Russell and Torch. . I sprayed WD40 into the switch before losing power to this terminal. As previously noted have power to two terminals out of five. Besides 17 not sure if other two terminals ought to have power. How does one open the switch?

Not insulted. Each of us blessed with different talents. Yes glow plug indicator using correct terminology. Terminals checked with key in both positions. Have power to terminals 30 and Ac in both key positions . No power to terminal 17 in either position

Terminal "17" has black with red stripe wire connected to it from first glow plug

It's a Kubota B8200. Have power to terminal marked "30" ( thick red wire) when key is OFF. Also power to terminal marked "AC "( thin red with white stripe wire) but only with key ON. The one I lost power to is terminal marked "17" (Black with red stripe wire)

Thanks Paul , I cleaned the earth cable connection and there's power past the fusible link. Two blade fuses are are ok.

Previous assistance appreciated and thanks to all who assisted. Thought I had starting issue on my B8200 sorted but but but !!! Previously all terminals at rear of ignition switch tested ok with test light. and tractor was starting ok. Now the terminal that connects to dash mounted pre...