Search results

Thanks Lugbolt, I measured the bottom layer off the old gasket and it is .008". Should I even go through the trouble of trying to piece it and the new gasket together? The original 3 layers are held together by a brass looking rivet that was pressed together. I'd have to drill those out and...

I agree with a safety switch, just don't know which one. I've seen them come out of the brackets, not letting the lever push in the plunger. Power and ground tight on battery and going to starter? Does the owners manual have the wiring diagram? Might could use that to jump the seat switch to...

I might could make a spacer from the old gasket, just would like to confirm it is 100% needed. Bores are good, no ridges at the tops, pistons don't rock. The block's deck is fine using a straight edge. The mower has very low hours according to meter; tires, mower deck and other wear items...

He replied back today with .008" taken off. I can't find in the service manual where it states at what measurement you need to use a thicker head gasket. Being that there is only one part number for the head gasket, makes me wonder. I called Country Sales and Service Friday to pick their brain...

I bought a ZD221 with the D782 engine that had been overheated from not cleaning the radiator. The previous owner took it to a Kubota shop and they said it needed an engine. I could tell they tried a new head gasket and replaced a bent push rod. I checked the head with a straight edge and could...