Search results

Put a flow rater in the remotes and see if it will achieve max flow at rated Rpms and pressure if not then it's your pump. If all of your hydraulics are affected except steering and you have good fluid and filters and no damage to suction lines then you probably need a pump.

The parts sub over to an updated seal. The seals look dif in appearance but they just updated the part. Very common failure on kubotas

Check your coolant temp and external block temp with a temp gun to see what your temps actually are before you go on you could be dealing with an electrical issue instead. I found with a lot of zds that the radiators had to be thoroughly cleaned almost every time you use them first with air then...

Did you remove the two lines at the tank? The lines are the same size but are different in the tank. The return line is restricted down while the suction line is full flow. It's hard to tell which is which by looking at the tank but the flow out from each will tell you. If not you ether have a...

Most likely needs a glow controller which is located behind the meter panel

Put your 3 point hitch down to see if your hitch is staying on demand. If you have a loader on the front move it around to see if the noise changes. Sounds like you have something on demand causing your machine to go over relief which is located in the block under the right floor board

If you have 23 hours on your tractor is very much over due for a regen. First off, if the warning indicator is on the Ecu will not allow the tractor to regen. The dealer will most likely have to hook up their laptop and do a forced regen if the tractor has not reached a level 5 which would...

It definitely sounds like a fuel issue. It could be as simple as something in your fuel tank. Blowing back in the lines would only temporarily solve the issue. If you look at your water separator it may be drawn down slightly when the problem occurs and then fill back up slowly. During the time...

You will want to hook in two place when hoisting on the engine. The hooking point showing in the picture will work fine and then just find another sturdy point to hook to on the other side that will give you an even lift point. I will sometimes bypass the hook they provide and find two more...

Re: Someone help me PLEASE. Kubota dashes from that range of bxs were horrible, moisture issues etc will need to be replaced but most likely has nothing to do with your running issue. If it only starts to die when you push the hst pedal you have an issue with your seat switch or opc wiring. If...